V W Beetle Tin Plaque

ON THE BACK, MARK THE CENTRE POSITION

DRILL 8mm CENTRE HOLE TO ALLOW CLOCK TO PASS THROUGH

EASIER TO START WITH A VERY SMALL DRILL AND WORK UPWARDS

PUSH CLOCK SPINDLE IN FROM THE BACK

CAREFULLY, LIGHTLY TIGHTEN THE BRASS NUT

ONLY ENOUGH TO PINCH AND HOLD IN PLACE

OVER TIGHTEN COULD DAMAGE THE GEARING

LOOK AT THE HANDS CAREFULLY

THE RAISED BOSS PART GOES ON THE CLOCK SIDE

LINE THEM ALL UP AT THE 12 O'CLOCK POSITION

USING 2 FINGERS EITHER SIDE OF THE HANDS , GENTLY PUSH ON.

ASSEMBLE THE HOUR HAND FIRST, THEN MINUTE, THEN SECOND.

ONLY GENTLE PUSH THE SECOND HAND IN,

IF YOU EVER WANT TO CHANGE HANDS AT A LATER DATE

LINE THEM ALL UP AT THE 12 O'CLOCK POSITION.

ONCE FITTED, TRIAL TEST BY TURNING THE WHEEL AT THE BACK OF THE CLOCK MECHANISM,

GOING THROUGH A 12 HOUR CYCLE TO ENSURE HANDS DO NOT TOUCH EACH OTHER

NEVER ADJUST THE TIME MOVING THE HANDS AS THIS COULD AFFECT THE GEARING INSIDE.