Introduction: For this workshop I have brought instructions and materials for you to make three different instruments typical of the Medieval period. But before we begin I would like to show you some instruments I have made, and discuss briefly some of the techniques I have used in making them, and relate how my methods compare to techniques current in the late Medieval period. You will find additional details about these instruments and techniques on my web-site.
I have brought a number of instruments that I have made over the years for your inspection: a navigational astrolabe, a planispheric astrolabe, and a torquetum (see the instrument page on my web-site). All of these instruments are fabricated from copper and/or copper alloys. I did not bring my cross-staff or armillary sphere because they are currently on display at the HSU Natural History Museum in their Millenium window display.
Navigational Astrolabe: This is the first instrument I made (c 1985). The body was cut out from a bronze plaque and is about 1/4" thick, as compared to authentic examples which are more like 3/4" thick in order to give them stability on a rocking ship in the wind. In this early example I made graduations using a protractor with a hole cut at the center and a steel rule firmly attached along the 0° line. I then scribed a vertical line on the astrolabe blank and attached the protractor with a bolt through a hole in the astrolabe's center. I could then scribe lines with the rule, aligning the degree marks on the protractor sequential with the vertical line. This was a simple, reasonably accurate, and inexpensive mode of graduation. Though I have never seen this method noted in the literature, it certainly would not be impossible in ancient times. Who knows, since we rarely have records from Medieval craftsmen, a variation on it may have been used by someone.
Planispheric Astrolabe: This instrument is made of copper and brass, both metals commonly used for instruments in Medieval times. The blanks were cut from 14 gauge sheet with a power saber (or jig) saw, and then trued up to round with a file on a wood lathe. Careful, this can be quite dangerous, as copper alloys are "sticky" and can grab, making the file into a deadly projectile!. And, of course, the spinning blank can act as a blade and slice a hand if you slip. For graduating this instrument I used a rotary table (commonly found in machine shops, though mine was modified from a micrometer actuated transit) with a fixed rule held above it. The metal blank was then centered and fixed on the table and lines scribed with a knife held against the rule. This enables slightly cleaner and deeper graduations than the scriber. This method of graduation would not have been used until the late 18th century with the advent of dividing engines. To cut out the rete I used a jewelers saw and then cleaned up with needle files. Note that this is an unlikely scenario for early craftsmen. High quality steel required to make the fine blades of jeweler's saws was not available until near the 19th century. Thus the rete's of astrolabes were probably made by drilling holes and then cutting and shaping with files.
Torquetum: The various circles were cut from brass stock after lay-out with wing-dividers sharpened to round points - you don't want any "knife-edge" as they will then tend to pull instead of cutting a clean arc (trammel points will work equally well, but you need something that can be locked at a dimension). The dividers were then used to layout the radius of the circle to give arcs at 60° intervals (note that this is theoretically absolutely accurate, the precision attained in laying out these divisions is limited only by your tools and your skill!). Additional divisions at 30° intervals were then accomplished by bisection. Bisection of the 30° intervals will then give 15° intervals, however, at this point division by divider becomes more problematic. This method of division was the method from ancient times through the 18th century, and in fact was used for observatory instruments through the 19th century. I did the remaining division using my "dividing engine," an extension of the method described for the planispheric astrolabe above.
Projects. Three simple projects were constructed during this workshop. These projects are illustrated along with instructions for construction and sample calculations via the appropriate instrument subpages:
© R. Paselk Last modified 13 March 2000