156B Week 7

Overview of Status of Analysis, Design, Fabrication, Tests, etc.

• • Spray mechanism design in progress 

  • Still looking for manufacturer for the atomizer

  • Theoretical simulation on whole design in progress

Accomplishments from Previous Week

• • Attend the meeting of manufacturers' resources, unfortunately, we didn’t find any companies that could manufacture us the desired sprayer. The sprayer we intend to make is rather meticulous.

  • Completed analysis on each spray mechanism we design and performance demonstration into comparison table 

  • Ideal sprayer schematic design in mind

  • Final report 70% finished

Goals for Next Week (list names after each item). Use specific and measurable objectives.

• • Finalize atomizer design

  • Keep look for and discuss with potential manufacturer resource

  • Successfully manufacture ideal atomizer design

  • Optimization on the anesthetic loss

  • Risk reduction test on the new spray tip

  • Analysis on performance result

Sponsor Comments from Last Meeting and Actions Taken to Address these Comments

• • Sponsor was satisfied with the project progress

  • Sponsor demands computer stylized photos of the device

Instructor Comments from Last Meeting and Actions Taken to Address these Comments

• • Good progress on the project

  • Instructor provide useful manufacturer resource for advices

Risks and Areas of Concern

• • The material choice of the new spray tip

  • The performance of the atomizer

Resources or Information Required but not Available

Schedule

• • Describe upcoming milestone

Implementation on the atomizer produced by manufacturer or self-manufacture.

• • Update Gantt chart.