Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Calibration of four low-speed cameras using Arduino
Redesign of High-speed camera and galvo assembly CAD
Accomplishments from Previous Week
Finished design proposal presentation
Finished re-centering of low-speed camera and conducted calibration using Arduino code
Ordered components for mounting high-speed camera and galvo
Generated a new CAD of high-speed cam and galvo assembly
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Finished the hardware setup of the system (including high-speed camera and galvo) (Mingcong and Zizhao)
Calibration, working on Arduino codes to make four low speed cameras could record with same frequency and duration. (Keren)
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Draft design for the assembly of high speed camera and galvo is good, but the 3-D print part should be replaced.
Actions: Would work on the looking for suitable mounts.
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
N/A (No meeting last week)
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
Risks and Areas of Concern
None
Resources or Information Required but not Available
N/A
Schedule
Successfully install the high speed camera and galvo system.
Update Gantt chart.
Budget (list amount spent and amount remaining)
Amount spent: 0
Progress on Report and Webpage
Drafted selected sections (week 2) of final report
Updated initial webpage for week 3.