Vinyl Sticker
The Vinyl Sticker
This is my digital version of my sticker on Inkscape. I used an ellipse to draw the border and then typed in the letters. I chose my desired font and then turned this image into a path, so the vinyl cutter can process and read the cuts.
This is the path version of the Vinyl sticker.
Then I uploaded my SVG to Corel Draw and followed the Vinyl cutting process, which is attached below.
Vinyl Cutting Process
Make a design on Inkscape.
Use split view to see how it will print and change stroke path.
Save as SVG.
Go to the MAC, and get a sticky sheet.
Place the vinyl paper to the sticky sheet.
Load the sticky sheet with the Vinyl paper into the Vinyl cutter.
After the sheet is loaded, click print on the MAC.
When it's done printing take the vinyl paper off the sticky sheet.
Use tweezers to peel the vinyl.
Peel the sticker and place it on transfer paper.
Use a squeegee and scrape the transfer paper to ensure your sticker is stuck without any air bubbles.
Stick your sticker where you want and at an angle peel the transfer paper.
I chose my desired color of vinyl, and then followed the Vinyl Cutting process, like in the step above. I used tweezers and weeded the vinyl cut. I then used transfer tape and stuck it at the bottom of my box.
The Final Sticker
Click me, to go to the next page!
Click me, to go back!