SHOP HEATERS

Heat Exchanger & Tube Cleaning: Removing soot, dust, and debris from internal heat exchangers or radiant tubes to maximize thermal transfer.

Blower Motor & Fan Blade Servicing: Deep cleaning heavy shop dust and overspray off fan blades, and lubricating motor bearings if applicable.

Burner Assembly & Orifice Cleaning: Clearing out cobwebs, dust, and carbon from main burner ports to ensure a clean, blue flame.

Flame Sensor & Igniter Polishing: Cleaning the flame rod and electrode to ensure reliable ignition and prevent safety lockouts.

Drive Belt & Pulley Adjustment: Inspecting, tensioning, or replacing worn drive belts on large belt-driven commercial shop units.

Casing & Vent Screen Dusting: Vacuuming out the internal controls compartment, electrical boxes, and louvers to prevent fire hazards from shop dust.

Gas Leak & Pressure Verification: Electronic testing of gas line fittings and verifying correct inlet and manifold gas pressure for propane or natural gas.

Flue & Venting Safety Inspection: Checking B-vent or single-wall exhaust piping for blockages, backdrafting, or corrosion that could leak carbon monoxide.

Limit Switch & Safety Control Testing: Verifying that high-limit switches, roll-out sensors, and air pressure switches correctly cut off gas if the unit overheats.

Thermostat & Wiring Diagnostics: Checking low-voltage wiring, wall thermostats, or remote sensors for proper cycling and calibration.

Combustion Air Adequacy Check: Ensuring the shop or garage has sufficient fresh air intake to support safe, clean fuel combustion.

Electrical Grounding & Component Audit: Testing transformers, relays, and capacitors to verify they are handling the electrical load safely.

Core Component Replacement: Installing replacement blower motors, gas valves, exhaust fans (inducer motors), and spark modules.

Safety & Sensor Upgrades: Swapping out failing high-limit switches, air pressure switches, thermistors, and control boards.

Shop & Garage Heater Installation: Professional, code-compliant installation of new overhead gas unit heaters, infrared tube heaters, or electric shop furnaces.

Exhaust Venting System Installs: Running fresh venting lines through shop walls or rooflines using proper clearances and fire-stops.

Gas Piping & Line Extensions: Running new natural gas or propane lines to optimal mounting locations within your workspace.

Thermostat & Timer Upgrades: Installing heavy-duty industrial thermostats, protective lockboxes, or programmable timers to save fuel when the shop is empty.