IT-100 MULTISYSTEM TV SIGNAL ANALYZE
PLANAR IT-12 DVB-S/S2 SIGNAL ANALYZER
IT-100 TV signals multisystem analyzer is designed to measure signals parameters of digital and analog television. The analyzer can be used when checking and servicing cable coaxial, fiber-optic or IP networks for receiving television and radio broadcasting, separate elements of network building and other radio electronic devices.
Measuring TV signals parameters:
Analog television: support for PAL, SECAM, NTSC standards.
Measured parameters: Level, Video/Audio, Carrier/Noise (inband and outband of video signal), modulation depth, unwanted modulation level (HUM), CSO&CTB distortion components level.
Cable digital television: support for DVB-C, ITU-T J.83 Annex B, C standards.
Measured parameters: power, MER, BER, constellation diagram, error analysis over time.
Terrestrial digital TV broadcasting: support for DVB-T, DVB-T2 standards.
Measured parameters: power, MER, BER, constellation diagram, echo diagram, error analysis over time.
Satellite broadcasting digital television: support for DVB-S, DVB-S2 standards.
Measured parameters: power, MER, BER, constellation diagram, error analysis over time.
IP digital television: support for UDP and RTP protocol, reception of the Transport Stream through unicast and multicast (IGMPv2).
Measured parameters: average bitrate, number of lost packets (for RTP), jitter of packets arrival interval.
Monitoring of TV picture and audio:
Monitoring of PAL, SECAM, NTSC analog channels
Monitoring of radio FM stations
Monitoring of digital channels with MPEG-1, MPEG-2, MPEG-4, H.264 encoding with SD or HD resolution
Monitoring of encrypted programs when installing the CAM module
Monitoring of IPTV channels
MPEG Transport Stream analysis:
Three-level analysis for compliance with the TR101290 requirements
Real-time analysis
Recording a transport stream to a file for further analysis
Support of measurements in fiber optic cable network:
Built-in optical receiver with a frequency range up to 2150MHz
Support of all measurements from the optical input
Measurement of optical signal power
Operating in the wavelength range from 1100 to 1650 nm
Replaceable FC and SC adapters of the input optical connector
Power supply of external devices:
Built-in remote feeding power supply from 5 to 24V
Support for DiSEqC protocol level 2.1
5W power of remote feeding power supply
Measurement of DC and AC voltage on the input RF connector
Interface Support:
USB 2.0 device for connecting the analyzer to a personal computer
USB 2.0 host for connecting FLASH drives
ETHERNET RJ45 10 / 100M for software updates, remote control and IPTV operation
PCMCIA port for connecting a CAM module
General specifications:
Operating frequency range: 5 to 2150MHz
Level measurement range: 20 to 120 dBμV
Level measurement accuracy: ± 1.2dB
Frequency step: 25 kHz
Sweep time in the spectrum mode from 70 to 250 msec
Built-in TFT color display 4.3 "with a resolution of 480x272 pixels
Built-in speaker
Operation from built-in battery and mains charger
Battery life: 4 hours
Analyzer weight: 1.5 kg
Operating temperature range: -10 to +500С