Mortiser

Mortiser

A. GENERAL SAFETY PRACTICES:

• • Do not attempt to mortise material that does not have a flat surface, unless a suitable support is used.

  • Always clamp workpiece securely to table with vise or hold down clamps to prevent lifting.

  • Always support workpiece securely against fence to prevent rotation.

  • Be sure drill bit is sharp, not damaged and properly secured in the chuck before operating.

  • Make sure chuck key is removed before starting the machine.

  • Adjust depth stop to avoid drilling into table.

  • Never place your fingers in a position where drill or cutting tool could contact them if stock should shift unexpectedly.

  • Make sure machine is securely fastened to a supporting surface to prevent it from tipping over.

  • Have qualified instructor double check/or help with any concerns before starting up the mortise/drilling machine .

.

Bank of Questions: (Motiser)

Missing words

Short answer Questions

Please state why each of the following represent a safety hazard.