If your HP ENVY 6055e WiFi is not working, the printer is rarely broken. On the related ENVY 6000 series, a blinking blue light means the printer isn’t connected to your Wi-Fi network. Printer Tech Services says a skipped setup step is usually the cause. Follow these steps in order.
Printer Tech Services lists four common causes: your phone switched Wi-Fi networks during setup, the password was mistyped, the router was changed and the printer still remembers the old network, or the printer is too far from the router. It also says the 6055e has no screen, so you can’t type a password on the printer itself. Setup goes through the HP Smart app.
An HP Support Community reply for the ENVY 6000e suggests unplugging your router for 30 seconds and turning it back on, then restarting your phone or computer and the printer. Keep the printer near the router. HP’s reply for a related model also recommends this when reconnecting after a router change.
This step clears the old network settings. For the ENVY 6000, 6000e, and 6400 families, HP’s reply says to press and hold the Wireless button on the back of the printer for five seconds, until the status light flashes blue or purple, depending on the model. Once the settings are restored, the printer stays in Wi-Fi setup mode for about two hours.
If that doesn’t start the blinking, another HP reply for the ENVY 6000 series says to hold the Wireless and Cancel buttons together for five seconds, then release them. The Wi-Fi light flashes again, which means the old settings are cleared.
Make sure your phone or computer is on your wireless network and you know the password.
HP’s datasheet says Bluetooth setup requires a device supporting Bluetooth v4.2 or later, with Bluetooth turned on. The HP Smart app must be installed and open, and the device must be within 5 feet of the printer.
Open HP Smart, tap Add Printer, choose your printer, and follow the Wi-Fi setup. Select your home network and type the password exactly as it appears on your router.
Printer Tech Services advises not switching screens or Wi-Fi networks while the app finishes.
When the Wi-Fi light turns solid, the printer is connected. To confirm, hold the Information button to print a network configuration page, and check that it shows an IP address and your network name.
Printer Tech Services says to delete the old printer in the HP Smart app and add it again, or it will keep trying the old network. Step 2 above clears the printer’s own old settings.
Try a 2.4 GHz network. An HP reply for the ENVY 6000e suggests connecting to a 2.4 GHz network. If the router merges 2.4 GHz and 5 GHz under one name, HP’s reply says to temporarily separate them or disable 5 GHz.
Try WPS. Hold the Wi-Fi button on the printer until it blinks, then press the WPS button on your router within 2 minutes.
Reduce interference. Printer Tech Services suggests keeping the printer away from microwaves and cordless phones.
Check Bluetooth. A weak Bluetooth signal can stop HP Smart from finishing setup. Move your phone closer to the printer.
When your HP ENVY 6055e WiFi is not working, restart your devices, restore Wi-Fi setup mode, and reconnect through HP Smart. Then print a network configuration page to confirm it worked.