Flower Crown

Procedure:

• First you are going to take your one piece of wire and wrap it around your head to get the general shape of your head where you want your crown to be.

• Now you are going to take the ends of the wire and create a separate loop for each end.

• For each loop you are going to wrap your floral tape tightly onto where the pointy end of the loop reaches the start of the loop, still having the loop exposed but making sure nothing pointy is sticking out and the loop is secure. 

• Next to start your flower crown you want to create a small bunch of flowers, each stem being smaller than an inch. It can be a mix or one type of flower. 

• Then you are going to take that bunch and use your floral tape to wrap it around your wire tightly facing one way and only on one side of the wire.

• Now you're going to repeat steps 4-5 all around your crown until you cannot fit any more onto the crown.

• Take note as you repeat these steps that you should be creating some sort of pattern or alternating flowers, what I did was Waxflower, Limonium, Baby's Breath, then a mixed bunch of all of them then I repeated that until the end.  

• When you finish with that you should check around your crown for any missing spots or any bunches that weren't big enough and you can fill in flowers with some more tape.

• Now you're going to take your ribbon and tie each piece of it to each side of your crown so it can be adjustable to your head since the wire only goes halfway around your head. 

• Finally sit your crown on your head and adjust the ribbon, wire, and anything else as needed. Then enjoy your flower crown!