General information about the Laboratory: The objective of this laboratory is to prepare students and to give advanced ideas of Electric Drives with Automation, PLC, and SCADA. Chopper-fed, Converter fed and cycloconverter-fed different types of motor control (open loop and closed loop) are available for the experiment purpose. Software study tools are also available such that students can relate them with software and hardware both. Special tool kits are also available for different types of braking studies. 

Utilization

This laboratory offers support for courses as listed below

UG Level:

• PC-EE-791 (ELECTRIC DRIVE LABORATORY) for 7th Semester, EE

• PW-EE 781/881 (UG Projects)

PG Level:

• CAM-292 (POWER ELECTRONICS AND DRIVES LABORATORY) for 2nd Semester, EE

 Software Used:

• PSPICE

• MATLAB

• PSIM

List of Experiments:

 A partial list of experiments offered by the laboratory is presented below.

1. Study of speed control of Thysistor-controlled DC Drive.

2. Study of speed control of Chopper fed DC Drive

3. Study of speed control of single-phase motor using TRIAC.

4. Study of PWM Inverter fed 3 phase Induction Motor control using software.

5. Study of VSI / CSI fed Induction motor Drive using the software.

6. Study of V/f control of 3phase Induction motor drive.

7. Study of permanent magnet synchronous motor drive fed by PWM Inverter using Software.

8. Study of Regenerative / Dynamic braking operation for DC Motor - Study using software.

9. Study of Regenerative / Dynamic braking operation of AC motor - study using the software.

10. Study of PC/PLC-based AC/DC motor control operation.