Wire ~ Cut into 1 - 6 " and 1 - 10" length. (Wire must be strong enough to hold a rubberband without bending. I use 17 gauge fending wire, but paper clip wire will work)
Needle nose pliers
Rubberband
Cardstock or Note Cards
Adhesive > Can use tape, duct tape, white glue or hot glue.
Scissors
Pencil or Pen
Check out my video on HOW TO MAKE A FLYING BUTTERFLY
Detailed Diagrams and Problem Solutions
6 " ~ Top Wing Wire
Make sure that the loop at the bottom of the "V" is small.
If the wings doing spin, it may be because the "V" needs to be stretched wider so the loop doesn't drop down into the bottom wire's ring so far.
10" ~ Bottom Wing Wire
It is VERY important that the center/top ring is ROUND. Wrapping it around a round barreled pencil or pen helps!
If the wings don't spin, it may be that your circle wire isn't round enough and it's catching. Take apart and reform.
This is a simple diagram of both wires and the rubberband connecting them