During the start of the project i was fiddling around with the settings. After i was satisfied of what is was doing and what all the settings do i went to see how thick the cardboard is. the answer was 0.33, but i made mine 0.30 for extra stability. I started making my box a box by making some holes in the sides where the cardboard would connect for a 3d box. than i added a stand for it. in total it isn't a full box, there are only 4 sides to it leaving a open. The S is just a symbol for decoration.

9/25

9/26

Today i just edited my box making it perfect. not a lot of changes.

9/28

Preview attachment 20170928_110142.jpg

9/29

Since my last box didnt fit together i down the size to 0.20. and made the length 1 inch. I also took the stand off and was making it a full box.

10/3

Today i was making another box, I have not printed it yet though because the printer was being used. Tomorrow ill probably print it.

10/4

I have been making box after box after box, and still have not succeeded at building a simple box.

I have made my final attempt to make a working box, everything is 0.20 or 0.40.

10/5

I FINISHED MY BOX, LOOKS GREAT AND WORKS GREAT, but did not survive the drop part

10/9

Here is my box photo of what it looks like now.

I tried to do a little trick with my box by making super tiny box and putting that tiny box in another box so once when that bigger box breaks the tiny one will hopefully survive. Sadly it did not survive.

I just adjusted my measurements by 0.05 and it helped a lot! it actually works now!

10/10

My box worked! 100% it survived the drop test and everything.

next i read how to make a sticker on the fab lab website. next i ask shannon for help with it. she help me make my illuminati.

10/12

Today i made a better sticker. it is a burning skull with the TTN logo.

These are the steps i used to make it.