Introduction to Engineering

In this assignment I got a 74 which is low and I could have reviewed my answers, double checked, and study before the test happened. I got a 85 in my final grade for the marking period so I didnt do that bad.

In this assignment I got a 78 higher than the other test so I can say I did improve. But I did reviewed my answer and double check. I just forgot to study the day before. 

In this assignment I got a 75 I understood the assignment which we where suppose to make a Lego block to get use to onshape. Making the corners and shape correct and it should be. 

In this assignment I got a 100 and I knew what to do since you had to make the box open and close as the top and bottom don't go past each other. 

In this assignment I got a 91 which is way higher than my other test I took. This time after actually studying my notes and checking word for word one my answers I got a really good grade that helped my overall grade. 

In this assignment I got a 66 not the grade someone is looking for but it was 3 questions so if you got one it's over. I got the one question because I was confused on if it was Structural or Functional analysis.

In this assignment I got a 92 and it was a 1 person to do the research and then it became a 2 person project and a google slide. 

In this assignment I got a 80 which is a decent grade but I could have made it a lot better with my ideas. I could have done everything I would have done. But the overall purpose was to see how prepared we are for the Engineering End of course.