Week 6

Overview of Status of Analysis, Design, Fabrication, Tests, etc.

• • Fabrication of the dry paint thickness verification complete, testing will begin this week.

  • Due to complications in ordering, we have decided to order a new spray head, waiting to get it approved by our contact

  • The frames of both the upper and lower sliders have been purchased and assembled, just need to attach motors and the sliding mechanism.

Accomplishments from Previous Week

• • Purchase and assembly of the spray head slider frame

  • Completion of the assembly of thickness verification method

  • New spray head finalized, waiting to be approved.

  • Finalized design to only have one sprayer.

Goals for Next Week (list names after each item). Use specific and measurable objectives.

• Communicate with our contact to finalize purchase of new spray head  Mario

  • Complete testing of the thickness verification Garrett

• Begin assembly for the braces to hold the sprayer slider in the air Chris M.

• Construct coupon holder Chris G.

  • Attach motor and screw driver to the table slider & CAD acrylic holder Danny

• Finalize motors to be used and how to attach them Abby

Sponsor Comments from Last Meeting and Actions Taken to Address these Comments

• • They said not to worry about cost, just about lead time

  • Both our contacts are out of town this week, we will be communicating with the paint expert Don Means.

Instructor Comments from Last Meeting and Actions Taken to Address these Comments

• • Concerned about the hold up on the spray nozzles, we have sent in an order for new purchase

Risks and Areas of Concern

• • Will the sprayers get here on time?

  • Once it does get here, will we have enough time to test with it.

  • Contact will be out of town all week,

  • DON'T forget badges!

Resources or Information Required but not Available

• • Vendor list

  • How long of a delay the purchasing process will take

Schedule

• • Describe upcoming milestone

    • Still waiting for spray nozzle

    • The table slider and spray nozzle support system have been constructed

    • Completion of the thickness verification

  • Updated Gantt chart posted to website

  • Continue fabrication of all parts needed for table and spray nozzles

Budget (list amount spent and amount remaining)

• • We purchased 2 spray nozzles for the cost at $1491.71

  • 36'' Steel Straightedge at $89.99

  • Aluminum Frame $378.61

  • DAC $280.00

  •  $8560 remaining from sponsor budget

Progress on Report and Webpage

• • Webpage is in full use