Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Physical setup mainly finished, need to modify compressor and test system with LN2
Accomplishments from Previous Week
Obtained LN2
Insulated the system
Wired electronics and programmed draft controller
Ran the system and collected running data
Built Plexiglas insulation cover box
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Report, website, and poster should be complete by end of week (team)
Obtain estimation of flow rate and heater efficiency from data obtained
Confirm heater is working properly
Refine controller and debug a malfunctioning RTD sensor.
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Sponsor will bring modified component for compressor so it will operate under the system's condition (3/9/2018 in person)
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
None
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
None
Risks and Areas of Concern
Running the system and data collection
Resources or Information Required but not Available
None
Schedule
Will modify compressor and collect data (3/13/2018)
Budget (list amount spent and amount remaining)
Spent: $2761.66
Remaining: $438.34
Progress on Report and Webpage
Updated webpage with final design solution and updating report with classmate's comments and suggestions