Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Tested Dyno with motor
Tested Water Brake
Tested RPM sensor with a trigger wheel
Accomplishments from Previous Week
Layout of Electrical Control Panel, and list of components and terminal blocks needed from Phoenix Contact
Met with Sponsor, saw a working dyno at Schlossnagel Racing.
Spoke with Phoenix Contact representative about getting parts donated
Acquired Fuel Cell
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Set weekly meeting schedule with sponsor
Purchase/acquire necessary parts for electrical control panel
Look into driveline/engine frequency analysis
Investigate various different inlet flow control elements and commercial off-the-shelf packages
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Sponsor showed team a working engine dyno
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Took note of instructor's comments on presentations on the final day of 156a, will address these concerns in future presentations
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
None
Risks and Areas of Concern
Driveline calibration with actual engine
Resonance frequency for engine
Wiring/mounting engine
Wiring and cable management for electrical control panel
Software implementation for easy to navigate UI
Resources or Information Required but not Available
Need to get numbers for driveline frequency/engine resonance
Schedule
Describe upcoming milestone
Update Gantt chart.
Budget (list amount spent and amount remaining)
$896 spent
$1104 remaining
Progress on Report and Webpage
Website updated with individual component analysis under Reports -> Docs