Overview of Status of Analysis, Design, Fabrication, Tests, etc.
The first set of hardware, ordered from McMaster Carr arrived on Friday.
All parts have been machined.
Assembly will occur on Mondau
Accomplishments from Previous Week
Fabricated motor endcap, and motor endcap chassis
Fabricated sensor endcap
Fabricated pressure case housing
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Rewrite each section of the report except the introduction. -Everyone
Assemble pressure case. -Jebsen and Thomas.
Assemble the winch. -Matt and Jonathan
Test the endcaps for waterproofing. - Merlin and Matt
Drill the whole for the motor shaft in the motor endcap and proceed to test rotary shaft seal. -Thomas
Write draft 1 of the controller code. -Merlin and Matt
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
none
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
none
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
none
Risks and Areas of Concern
There is a risk that the assembly will fail waterproofing tests. Such a failure could be attributed to one of several causes. Determining the source of failure and correcting the problem could put s behind schedule.
Resources or Information Required but not Available
none.
Schedule
Waterproof testing will occur this week
Budget (list amount spent and amount remaining)
Amount spent: $649
Amount remaining: $1851
Progress on Report and Webpage
No updates were made this week