The most important to the functions of the product are:

• Weight

• Durability

• Cost

Cylinder Assembly

1. Cut the 1” diameter cylinder (6) to 5.669” using a band saw and proper safety equipment

2. Cut the ½” diameter cylinder (7) to 8.726” using a band saw and proper safety equipment

3. Using a ¼” drill bit and proper safety, drill 5 holes directly through the 1” cylinder at set lengths

4. Place the ½” diameter tube into the 1” diameter tube and secure them together using wire lock pins (10)

Base Assembly

1. Design the bases using Autodesk Inventor and 3D print it using PLA filament.

2. Once finished printing, detach from the print bed using a paint scraper.

3. Attach the bottom of the ½” diameter cylinder (6) to the base using the holes provided and the length of all-thread (9).

4. Place round knobs (11) on the ends of the all-thread to secure the ½” tube inside the base.

Yoke Assembly

1. Design the 3 yokes using Autodesk Inventor

2. 3D print the yokes and remove from the tray using a paint scraper when finished

3. Attach the tripod adapter (2) to the tube cap (3)

4. Secure into place using a nut (4) and screw (5)

5. Slide the 3D printed endcap over the end of the 1” diameter tube

6. Screw the yoke into the tripod adapter.

**Assembly note: There are three yokes and two bases available, they are interchangeable and can be switched out using the same instructions written above.