Primitive tool for creating pipe objects.
Using: Snapping & UCS, Boolean, UV Maps
Primitive profile types:
Square
Circle
Primitive parameters:
Width: size of pipe profile.
Sides: subdivision of circle profile.
Pipe is based on Chain tool.
Rail curve modes:
Line:
Curve:
Round:
Rail parameters:
Rail Divisions: rail curve subdivision.
Offset Mode: types of offset modes
Offset: offset of the rail from the workplane. If UCS is of then it is offset of each point from the surface which was last snapped
Locked: seamless connection between end points.
AutoLock: automatic locking when end points are on the same position.
[Close]: connects end points.
[Delete last]: delete last point.
Active point parameters:
Index: index of currently edited point.
Position: position of edited point.
Adjust Mode: type of adjusting. Adjusted can be 'Single point' or 'All points'.
Weight: weight parameter of active rail point.
Radius: radius parameter of active rail point