Lily Mitchell's ePortfolio

Solidworks Practice problems

Practice 9.1 A & B

Practice 1.6

In the instructions the mass is 24032 cubic mm and it is symetric which mine is however it has a slightly smaller volume.

Practice 2.4

The volume in the instructions was 42236 cubic mm and this time I was within 10 cubic mm with a missing dimension.

Practice 3.4

The volume in the instructions was 9921 so I was just .15 off

Practice 3.5

132122 cubic milimeters was the target, i wasn't as accurate as I would like.

Practice 4.8

The instructions had a volume of 258631 cubic millimeters so 1 was off by 0.31.

Practice 4.16

164805 was the target volume and I was within 7 units

Practice 5.13

358642 cubic millimeters was the volume the directions had and I got 358643.41

Practice 6.1

I was off by a decent amount in the volume however I beliebe that is due to the fact chess pieces are hallow and I didn't make this model hallow.

Practice 6.14

The volume in the instructions was 33945 so I was only off by 0.86

Practice 7.4

The document has the volume at 421 cubic millimeters which is less than 1% off

Practice 8.4

I was off by less than 0.01

Practice 9.1 A & B

For this first assembly the angle inbetween the pliers was 45 degrees and then this second picture has a angle of 8 degrees.

Practice 9.3

The angle of the two pieces is changed from A to B but it isn't that noticable from these pictures.

Page updated

Google Sites

Report abuse