Quick Start Hummingbird with Snap

Hummingbird Quick Start Instructions

Plug the Hummingbird into the Mac USB port.

Start the BirdBrainRobotServer app (icon is a light bulb).

The app should say that the Hummingird Duo is Connected.

(If not stop the app and make sure the Hummingbird is connected and the status LED is slowly blinking, then restart the app.)

Click on “Open Snap!”

Read the note in Snap informing you where the blocks for the Hummingbird are.

So far the software has been installed on –

MacBook Pro BC 77658380 (in MakerSpace lab)

MacBook Pro BC77658378 (in MakerSpace lab)