Canon pixma pro 100 setup

How to Setup or Install Canon PIXMA PRO-100S Driver:

  1. Once the download is complete, click Open Folder, next click the downloaded file.

  2. You could accept the default area to conserve the file. Click Next, and then wait while the installer draws out the data to get ready for installment on your computer or laptop.

  3. NOTE: When the download is complete, search for the folder where you saved the file driver documents and then double click.

  4. When the Install Wizard starts, comply with the on-screen guidelines to set up the software.

  5. When finished restart your computer system or laptop computer.

  6. Then do an examination print as well as check review.

Don't Miss - Canon pixma pro 100 setup

How to Uninstall Canon PIXMA PRO-100S Driver:

  1. Open Start Menu.

  2. Click Control Panel.

  3. In Control Panel menu chooses to Uninstall a Program.

  4. When the Uninstall Program menu opened, click that the driver printer would be you like to uninstall.

  5. After an uninstalling process is complete, don’t forget to restart your computer, So that the computer was working normally again.

Canon PIXMA PRO-100S Wireless Setup:

WPS Connection Method

Step 1

  1. Make sure that the Canon PIXMA PRO-100S printer is turned on.

  2. Press and hold the [Wi-Fi] button on the front of the printer for a few seconds.

Step 2

  1. Make sure that this button starts to flash blue and then go to your access point and press the [WPS] button within 2 minutes.

  2. For exact details regarding pressing the WPS button, please refer to the access point manual.

  3. The (blue) Wi-Fi lamp on the printer will continue flashing while searching for, or connecting to the access point. When the printer has successfully made a connection to your wireless network, the blue lamp will stop flashing and remain lit.

Network settings confirmation

  1. Make sure that your Canon PRO-100S printer is turned on.

  2. Load a sheet of A4 or Letter-sized plain paper.

  3. Press and hold the [Resume/Cancel] button until the power lamp flashes 6 times, and then release it. The network information page will be printed.

  4. When referring to the printout, check that the “Connection” indicates “Active” and that the SSID – Service Set Identifier (the name of your wireless network) indicates the correct name of your wireless network.This concludes the WPS setup procedure.

  5. Please now proceed by installing the software to make the most out of your PIXMA PRO-100S.

  6. If you do not have the installation CD that came with your product, you can download the manuals and software by selecting your product from the PIXMA range page.

  7. If the wireless setup is still failing after following this guide, please contact us for further assistance.

Other Source - Canon Pixma MX922 Printer Setup