Receiver Setup:

Channel 1 = servo

Channel 2 = servo

Channel 3 = Electronic Speed controller (ESC)

*** Think "Brown down, because ground is brown". The Brown wire goes on the far side of the channel labels. 

Transmitter Setup:

Turn on/off Elevon Mode

1. Hold "Ok" until you hear a beep

2. Click "Up" (box around the wrench icon)

3. Click "Ok"

4. Click "Down" 8 times, or until the arrow is beside "Elevon"

5. Click "Ok"

6. If  "Elevon On" Click "Cancel"

7. If "Elevon Off" Click "Up" to turn elevon mode on

8. HOLD "Cancel" until it beeps to save changes

9. Click "Cancel" 2 times, or until the main screen is shown.

10. All Done!

Correcting output vs input (Reversing Channels)

1. Hold "Ok"

2. Click "Up" (box around the wrench icon)

3. Click "Ok"

4. Click "Ok" (Arrow defaults on "Reverse")

5. WARNING - Unplug one of the three Motor wires to avoid throttle reversal. DON'T reverse Channel 3.

6. Note: "Ok" Moves the arrow.

7. Note: "Up" and "Down" both Reverses/unreversed the channel

8. When done, HOLD CANCEL TO SAVE CHANGES