Drawing paper two ( done only drawing )
MY FAVORITE VOODOO STICH GHOST DOLL<3
ALSO MY FAVORITE GHOST
As you can see i did NEARLY all my coloring but i didn't really finish the last two because i've spoted a mistake i made, The magical hat and the voodoo ghost doll has a problem with the grabbing hole at the bottom.
Some parts are the middle layer which I cannot fit these grabbing holes ( these grabbing holes are for holding the LED lihts inside but it is also supposed to be in the front layer [first layer] ).
The voodoo ghost doll that needs to be
RE-DESIGN
The magical hat that also needs to be
RE-DESIGN.
My development paper work ( I have choosen the ghost).
My card layers ( Blue, Pink, Pink ). the first layer is a normal ghost but there's holes to the second layer. The second layer is just plain pink and so is the last layer, the middle layer have devil horns ( its cute~ ).
For my ghost design...
Im going to take out one of the horn.
put the hand down.
make the head more flat
cut it in half then make it wider to fit in the drawing box
Change the colours to be RES, BLUE AND PURPLE
My final design, the ghost. (changes, layers, colors, and writings)
The ghost has rosy red heart (shaped) cheeks, only one horn, a flat top and a flat side, the ghost's face is upside-down (because the dead mostly do things oppositely / differently), dark purple eyebrows.
When we do our design on onshape it'll be quite hard to shape THE design. The color will look darker than when we want (maybe). We might not even get the shape we want at the end! There will be lots of tools to use for designing (your design).
So now that i've done with my final design I could go edit and start makeing my design on onshape.
My onshape work.
I have finished the shape and did the holes. I'll put in the colors later ( once im done with the other little bits ).
^ ^
Side layers ^ layers ( through hole [ veiw ] ) ^
Top Layer
Middle Layer
Bottom Layer
The Whole thing together
Features and Parts
this is also the 'Features and Parts'
---------->
Appearance panel
The appearance panel is for selecting colors for your design on layers.
Camera and render
This tool is for rotating your design into different angles to see different parts of the design.
Extrude Tool
The Extrude tool is for either adding or removing parts we dont need.
^
Tools Bar ^ Tools Bar Helps us make our design examples :
LINE TOOL
The line tool is used for creating lines on your design together with the spline tool you can create a design like mines!
-------------->
SPLINE TOOL
The spline tool is opposite of the line tool, the spline tool allows you to curve your design line.
--------------->
TRIM TOOL
Bottom layer
Middle layer
Top layer
<--------The pro's ( gail and aticha )
smoothing-
Bottom
Top
right side
Left side
The inside-out phantom - slides.
packaging