If your BBC micro:bit hardware is connecting as a drive called MAINTENANCE instead of MICROBIT, then you are in the maintenance mode provided for updating DAPLink software.
The way you access maintenance mode is by pluging in your board to your computer's USB port while holding down the reset button. If you are in maintenance mode by mistake, this might be how it happened.
To leave maintenance mode, unplug the board from USB, make sure the Reset button is not pressed, and plug the board back in.
The board should now show up with the correct name (for example, MICROBIT).
If this fails to work you need to follow the steps outlined in “Updating your DAPLink firmware”