Grass clearing using a grass blade

Grass trimming with a trimmer head

Trimming

• A grass blade is used for all types of tall or coarse grass.

• The grass is cut down with a sideways, swinging

movement, where the movement from right-to-left is the

clearing stroke and the movement from left-to-right is the

return stroke. Let the left-hand side of the blade (between

8 and 12 o’clock) do the cutting.

• Hold the trimmer head just above the ground at an angle.

It is the end of the cord that does the work. Let the cord

work at its own pace. Never press the cord into the area

to be cut.

• If the blade is angled to the left when clearing grass, the

grass will collect in a line, which makes it easier to collect,

e.g. by raking.

• Try to work rhythmically. Stand firmly with your feet apart.

Move forward after the return stroke and stand firmly

again.

• Let the support cup rest lightly against the ground. It is

used to protect the blade from hitting the ground.

• Reduce the risk of material wrapping around the blade by

following these instructions:

1 Always work at full throttle.

2 Avoid the previously cut material during the return

stroke.

• Stop the engine, unclip the harness and place the

machine on the ground before you start to collect the cut

material.

• The cord can easily remove grass and weeds up against

walls, fences, trees and borders, however it can also

damage sensitive bark on trees and bushes, and damage

fence posts.

• Reduce the risk of damaging plants by shortening the

cord to 10-12 cm and reducing the engine speed.

Clearing

• The clearing technique removes all unwanted vegetation.

Keep the trimmer head just above the ground and tilt it. Let

the end of the cord strike the ground around trees, posts,

statues and the like. CAUTION! This technique increases

the wear on the cord.

WARNING! Neither the operator of the

machine nor anyone else may attempt to

remove the cut material while the engine is

running or the blade is rotating, as this can

result in serious injury.

Stop the engine and blade before you

remove material that has wound around the

blade shaft as otherwise there is a risk of

injury. The bevel gear can get hot during use

and may remain so for a while afterwards.

You could get burnt if you touch it.

• The cord wears quicker and must be fed forward more

often when working against stones, brick, concrete, metal

fences, etc., than when coming into contact with trees and

wooden fences.

• When trimming and clearing you should use less than full

throttle so that the cord lasts longer and to reduce the

wear on the trimmer head.

Cutting

WARNING! Watch out for thrown objects.

Always wear eye protection. Never lean over

the cutting attachment guard. Stones,

rubbish, etc. can be thrown up into the eyes

causing blindness or serious injury.

Keep unauthorised persons at a distance.

Children, animals, onlookers and helpers

should be kept outside the safety zone of 15

m. Stop the machine immediately if anyone

approaches. Never swing the machine

around without first checking behind you to

make sure no-one is within the safety zone.

• The trimmer is ideal for cutting grass that is difficult to

reach using a normal lawn mower. Keep the cord parallel

to the ground when cutting. Avoid pressing the trimmer

head against the ground as this can ruin the lawn and

damage the tool.

• Do not allow the trimmer head to constantly come into

contact with the ground during normal cutting. Constant

contact of this type can cause damage and wear to the

trimmer head.

Sweeping

• The fan effect of the rotating cord can be used for quick

and easy clearing up. Hold the cord parallel to and above

the area to be swept and move the tool to and fro.

• When cutting and sweeping you should use full throttle to

obtain the best results.