00.) B.O.M.

Here you can find a list, with links, of the required tools, materials and components for creating a PaperSynth circuit.

For building the paperSynth:

1.) Soft Potentiometer 50mm: from Digikey, here.  (order 1 per 1 participant)

2.) 8 Ohm Speaker: from Amazon, here.  (order 1 per 4 participant)

3.) ATTINY85 Chip: from Digikey, here.   (order 1 per 1 participant)

4.) 8-pin IC Socket: from Digikey, here.   (order 1 per 1 participant)

5.) Potentiometer: from Amazon, here.   (order 1 per 20 participants)

6.) LED strip segment: from Amazon, here.   (order x1 per 120 participants)

7.) 220 Ohm Resistor: from Digikey, here.   (order 1 per 4 participants)

8.) Pushbutton Switch: from Amazon, here.    (order 1 per 100 participants)

9.) Coin Cell Battery x2: from Amazon, here.   (order 1 per 20 participants)

10.) 1/8 Inch Copper Foil Tape: From Amazon, here.   (order 1 per 8 participants)

11.) 1 Binder clip: From Amazon, here.  (order 1 per 144 participants)

12.) Craft Board or Card Stock From Amazon, here.

13.) paperSynth Schematic/Template: See below

14:) Spray Mount: $9.41 from Amazon here.

15.) Super Glue: $5.56 from Amazon, here.  (order 1 per 8 participants)

Required Tools:

1.) soldering iron and solder 

2.) scissors and/or x-acto knife

3.) small pliers 

And if you havent programmed an ATTINY85 before, you might need these:

1.) Arduino Uno Board: $21.00 from Amazon, here.

2.) Breadboard: $4.66 from Amazon, here.

2.) Jumper Cables: $7.50 from Amazon, here.

3.) 10UF Electrolytic Capacitor, $1.05 from Digikey here.