software

wings of freedom

"Attack on titan "

I inserted the file into Fusion 360

Then I uploaded the real mobile dimensions and started drawing on the program

I started by drawing the outline of the design according to the specified sizes, then I inserted the image inside the design

Then I began to draw the positions of the holes through which the nail and the protruding parts of the wood would pass,

And with that, we have finished the front part of the mobile holder.

I started by drawing the back part on which the mobile holder will rest

It is a rectangle with two prominent parts that will cross from the other piece

And in the middle I draw the position where the nail will rest

I gave a thickness to the two shapes together and put them together, each part in its place

To finally give me the complete design.

After I saved the DXF file, I inserted it into Corel Draw to erase some extra lines and modify the internal drawing of the design and to avoid overlapping the lines when drilling

Then I inserted the file into the Laser Work program to determine the cutting and drilling positions, and to control the speed and power.

Thus, the file is ready to be sent to the laser cutting machine

I sent the file after modification from the Laser Work program to the machine and named it my name

Then I moved to the machine screen

And the machine was already running

I searched for my file and gave the command to start and it took about three and a half minutes and it was finished cutting the design.

When I went to the lab and presented the design to Eng. Amany, who drew my attention to the fact that the design would change when the machine was digging due to the overlapping of lines and graphics inside it.

And she advised me to use Corel Draw and erase some Lines from the design and change it a little.

Also, Eng.Ahmed ibarahim had advised me to use that program in advance when I presented the design to him in a Saturday session in the lab.

Assignment Design Files