Overview of Status of Analysis, Design, Fabrication, Tests, etc.
We have begun machining parts
We have tested 2 motor drivers, both work but only one has built in current limiting capabilities
Accomplishments from Previous Week
Finalized drawings
Made acrylic mock-up with correct dimensions for sponsor to take to lab in Taiwan
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Have all parts done being machined - All
Begin assembly of load frame - All
Begin software interface and control - All
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Sponsor going to Taiwan during week 6, 4/27 in person - We made a mock-up for him to take
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Make sure Arduino reference voltage is same as ADC shield and Potentiometer reference voltage (4/27, in person)
Look at bathtub flooring grip from Home Depot for surfacing grips (4/27, in person) -
Let him know ASAP if we want to anodize our grips (4/27, in person) - Not pursuing this option
Could use temperature sensor with kill switch to avoid overheating motor (4/27, in person) - One driver has built in current limiting
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
N/A
Risks and Areas of Concern
N/A
Resources or Information Required but not Available
N/A
Schedule
Have all parts machined and have load frame assembled by end of week 7
Purchase hardware by end of week 6
Budget (list amount spent and amount remaining)
$641.49 spent
$858.51 remaining
Progress on Report and Webpage
1st draft of report and webpage submitted