Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Consulted with Ian Richardson about design
Looked at component room, checked ball screw and linear bearings
Accomplishments from Previous Week
Took a much needed break
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Complete individual component analyses (Sensor - Nathan, Motor/Ball Screw - Nathan, Controller - Clint, Frame/Guide Rails - Andrew)
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Confirmed minimum resolution
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Check out optical sensors and labVIEW cards
They are most likely too expensive, but we will be asking our sponsor about increasing the budget
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
Have better communication with sponsor's colleagues in Taiwan
We did not express this well in the presentation, but we have been communicating extensively with the lab in Taiwan
Risks and Areas of Concern
None
Resources or Information Required but not Available
None
Schedule
Individual Component Analysis due this Friday 4/1
Website progress and Week 2 Progress Report finished by Tuesday 4/5
Budget (list amount spent and amount remaining)
$0 spent, $1500 remaining
Progress on Report and Webpage
No progress on report
Met with Ian Richardson to fix website permissions due to team member switching, and finished Week 1 progress report