Week 6

Guidelines for Report

• Analysis: Complete

• Design: In Progress

  • Evaluate proper housing – In Progress

• Fabrication: In Progress

• Create Test Bench - Complete

• Conduct Preliminary Testing - Complete

• Testing: In Progress

• Evaluation: In Progress

• Report: In Progress

Overview of Status of Analysis, Design, Fabrication, Tests, etc.

• • Final Stages of Testing

    • Need to enter calibration retest

Accomplishments from Previous Week

• • Obtained Calibration Curves for both Flow meters

Goals for Next Week (list names after each item). Use specific and measurable objectives.

• • Begin thinking about designs for mounting device (3D printer)

Sponsor Comments from Last Meeting and Actions Taken to Address these Comments

• • Perform 1-hr tests- in progress

  • Enter calibration and retest- in progress

  • Redo tests for 7607 meter- complete

Instructor Comments from Last Meeting and Actions Taken to Address these Comments

• • Talk to supplier about calibration-Sponsor will make call to Germany

  • Talk to Bart Chadwick about next quarter's project-Complete

Risks and Areas of Concern

• • Flow meters will not be able to compensate for Calibration-may need to perform calibration after collected data

Resources or Information Required but not Available

• • Supplier over-ride for Flexim computer for calibration

Schedule

• • Work on Transducer pipe mount designs (Jun and Zeeshan)

  • Combined Test Rigs to test both setups at same time (Scott)

  • Update Gantt chart (Becky)

  • Analyze and Report Test Data (Becky)

Budget (list amount spent and amount remaining)

• • Spent: $15

  • Remaining $985

Progress on Report and Webpage

• • Webpage updated

  • Report Draft Finished