Week 5

Guidelines for Report

Overview of Status of Analysis, Design, Fabrication, Tests, etc.

• Analysis: Complete

• Design: In Progress

  • Construct test rig and test bench - Complete

  • Evaluate proper housing – In Progress

• Fabrication: In Progress

• Create Test Bench - Complete

• Conduct Preliminary Testing - Complete

• Testing: In Progress

• Evaluation: In Progress

• Report: In Progress

Accomplishments from Previous Week

• • Collected Data for both Flow Meters

  • Fit calibration curve for both meters

Goals for Next Week (list names after each item). Use specific and measurable objectives.

• • Analyze data and input Calibration

  • Redo Calibration sets to ensure correct

Sponsor Comments from Last Meeting and Actions Taken to Address these Comments

• • Input data into CMA excel sheets, so get accurate calibration: done

  • Compare calibration to old calibrations: comparison similar for one meter

Instructor Comments from Last Meeting and Actions Taken to Address these Comments

• • Work on Report- Outline Created, Finished by Thursday

Risks and Areas of Concern

• • Flow meters have an upper limit on the slope and offset adjustments that can be made from the calibration

    • upper limit is 2, we need to input 2.5

Resources or Information Required but not Available

• • Can we over-ride the upper limit in the factory setting?

    • need to contact Flexim for more information

Schedule

• • Tuesday: Presentation

  • Wed/Thurs: Finish Draft of Report

  • Thursday: Continue Calibration, show results to CMA

  • Friday: Brainstorm plans for mounting

Budget (list amount spent and amount remaining)

• • Spent: $15

  • Remaining $985

Progress on Report and Webpage

• • Report Outlined