Embedded Files
Look at the anatomy of a breadboard and other components and then build the circuit pictured below. It is important that the wires and components that are joined in the each set of 5 holes match the diagram. It doesn't matter if the wires and components go into a different set of 5 holes.
So, you can put the LED further to the right and as long as the purple wire is in the same set of 5 holes as the long leg and the orange wire is in the same set of 5 holes as the short leg, the circuit will be the same.
Click on the image to go straight to Tinkercad Circuits! The image contains a hyperlink!
If you have not used Tinkercad before, click on:
You may need to come back here and click the link again to go directly to the circuit once you have signed up.
You can run the simulation to test the circuit and then edit the circuit and/or code and retest! Have fun 😎
Page updated
Report abuse