Download PrusaSlicer Standalone. This does not require installation so can be used by any user without Administrator privileges.
Run the PrusaSlicer executable downloaded above.
Choose to install "Only for me"
Leave all options at default values
When installation is complete, launch PrusaSlicer from the start menu
When the wizard appears perform the following actions:
Prusa FFF - Select "None"
Custom Printer Setup - Check the box
Click "Finish" on the bottom of the screen
Download the pre-configured "Config Bundle" from the link below:
PrusaSlicer Config Bundle for Bearcats modified MakerGear M2
Import the downloaded config bundle from the menu in PrusaSlicer:
File -> Import -> Import Config Bundle
TODO
TODO: Download Pronterface: Is this is our best option?
Preheat
Send print
Watch first layer
etc...
Wait for cooldown before turning off power - WILL CAUSE JAMS IF YOU DO NOT