Embedded Files
Empowering Today’s Learners to Become Tomorrow’s Leaders
New>Part>OK
Change units to MMG
In the Right Plane, sketch out the profile below. Be sure to include construction (centerline) line on the bottom left edge of the amp
Extrude 68mm for IPhone 4 and 81mm for Iphone 6 at the Mid Plane
Define a new Plane
Make New Sketch on Plane 1. Draw rectangle 55mmx120mm
Select the Construction (centerline) line and Midpoint of the bottom line of the rectangle and make them Pierce
Exit the Sketch and choose Insert>Boss/Base>Boundary
Shell Front and top of the amp as shown in the image
Create New Sketch as shown on the image below
Draw the cutout of the bottom section of the phone, as show in the image
Extrude Cut Up to Next for the phone cutout
Fillet the edges 2mm as shown in the image
Create New Sketch on the Right Plane
Make the sketch as shown in the image. Then Extrude Cut 12mm from the Midplane
Create New Sketch on the slot that was created in step 15
Make the sketch as shown in the image. Then Extrude Boss/Base at 3mm and reverse it
Make New Sketch on the same surfaces, just like two steps before.
Draw and Dimension the entities as shown on the image
Extrude Boss/Base 3mm and Reverse direction
Mirror Features, select Boss-Extrude3 & Boss-Extrude4, use the Right Plane to mirror about
Create New Sketch as shown in the image
Change your display to Hidden Lines Visible. Draw and Dimension the entities as shown in the image.
Extruded Boss/Base as shown in the image below.
Make a New Sketch in the Right Plane
Create the support by using Convert Entities, Trim tool and the Line tool.
Extrude Boss/Base with a Offset of 13mm. Direction1 extrude by the Mid Plane at a 2mm thickness
Change the Display to Shaded with Edges
Make a Linear Pattern feature of the support as shown in the image
Now Mirror those two features
Fillet the back of the stand at 1mm as shown below
Select the blue face in the image. Insert>Face>Delete.
Click OK to accept
Fillet using Full Round option as shown in the image
Fillet using Full Round option as shown in the image
Fillet the edge 3mm using Constant size option
Fillet edge in the image to 3mm
Fillet the following edges to 1mm
Fillet the following edges to 1mm
Fillet the following edges to 1mm
Fillet the following edges to 1mm
Fillet the following edges to 1mm
Fillet the following edges to 3.5mm
Fillet the following edges using the Variable Size Option as seen in the image.
Fillet the following edges using the Variable Size Option as seen in the image.
Fillet the following edges to 1mm.
Fillet the following edges to 1mm.
Apply a decal to your Amp. Select Render Tools and choose Edit Decal. Choose Browse and select your decal. Click on the surface you would like it on. Position, Resize and Rotate as needed
Page updated
Report abuse