Overview of Status of Analysis, Design, Fabrication, Tests, etc.
Prototype was built and tested in the last week
Currently troubleshooting issues encountered in prototype performance
Accomplishments from Previous Week
Finished Arduino libraries and automation code
Mechanically constructed the entire electromechanical system
Wired the system to test automation performance
Goals for Next Week (list names after each item). Use specific and measurable objectives.
Calibrate and tune system to make it run properly (Manuel)
Run tests and debug code (Manuel)
Provide software documentation (Manuel)
Provide mechanical documentation (Kieu, Angela, Alanna)
Sponsor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Sponsors expressed desire to see a short demonstration of the system
Instructor Comments from Last Meeting and Actions Taken to Address these Comments (indicate date of comments and if via email or in person)
Instructor helped with issues concerning reimbursements and budget
Comments from Other Students in the Class (indicate date of comments and if via email or in person)
No comments from other students in the class were provided
Risks and Areas of Concern
Motor drivers experienced issues with overheating
Low speed of translation movements
Resources or Information Required but not Available
Never gained access to machine shop or design studio
Schedule
Troubleshoot issues with system
An updated Gantt chart is provided in its tab
Budget (list amount spent and amount remaining)
Progress on Report and Webpage
Adjustments to the report and webpage are being made in light of feedback and continued progress