We used Fusion 360 to design our 3D print models. Because this was our first time using the program, we were allowed to just play around with it and create anything that came to mind. I decided to make miniature ring rack. I used the "fillet" tool to make the tops rounded. As shown in my design, under the curves there were not supposed to be pillars under the hooks. I made the mistake of not flipping the print upside down on Cura (as shown to the side) and instead keeping it upright. It was a shock to see that there were pillars; however, I came to enjoy the look of the pillars more than the overhangs, so I kept them and did not reprint. They also proved to be more efficient when holding rings. (Original file below. Link)