The outdoor video boards are controlled by a Novastar TB6 multifunction control box. It is solely responsible for sending the output media from vMix to the video board. The box is connected to the laptop via an HDMI cable. The box is connected to the inverter via Ethernet. The inverter is connected to the video board via fiberoptic.
Note: The TB6 does NOT carry audio.
Front Panel
LED Lights
Power
Cloud (not available)
SYS
Run
Switch Button
Move between async and sync modes
Top Row - Back Panel
Temperature Port (not used)
Light Port (not used)
Gold Connectors (not used)
WiFi AP
WiFi STA
Com1
LAN (network connection point; not used)
USB Ports (for shows saved on thumb drive; can use, but not user friendly)
HDMI In (connect the laptop HDMI cable here)
HDMI Out (not used)
Audio Out (not used)
LED Out Connections
Use 1 or 2 to connect laptop to sender box
Backup ports are not used
Soccer is equipped with the only wireless transmitter and receiver system. This system is a lot less complex on the end user side, however it has the potential to experience intermittent signal loss at times. If the signal is lost, try moving the transmitter to the left most side of the press box as possible. If it does not reconnect, you may need to power-cycle the device off and back on.
HDMI Input (from the laptop)
Power supply
On/off switch
Other than these three locations, you should not have to interact with this box much at all. If something is wrong or not working, reach out and we will see about getting it fixed, although it may not be immediate.