Embedded Files
Desk Topper
Desk Topper
Criteria
Must be designed in SolidWorks
Prepared in a slicer for additive manufacturing
3D printed in PLA filament
The object cannot take up more space than as 80mm sphere.
Unlike the previous year, you must create a ring to fit over the vertical monitor support. Make sure to use a caliper to measure. Don’t rely on a peer’s measurements. The object will then somehow be attached to the side of the ring so that the other student from the other class can also display their project on the other side of the support.
Test prints for the ring support are required before full prints (this has to be displayed on the ePort).
3D Gif of desk topper
3D Gif of desk topper
Moving around
3D Gif of Slicer
3D Gif of Slicer
Showing layers
Gif of 3D desk topper
Gif of 3D desk topper
Moving in hand
Test ring
Test ring
35 Diameter circle to fit on topper
Had to make an attachment because it wouldn't fit
Had to make an attachment because it wouldn't fit
Video of it moving
Gif of Slicing
Gif of Slicing
Going up and down in slicer
Attachment on topper
Attachment on topper
Attachment completed
Assembly of how part is going to fit
Assembly of how part is going to fit
Extruded circle will fit into the hole cutout
Completed desk topper
Completed desk topper
With the attachment on working to allow the original to fit
Page updated
Google Sites
Report abuse