The first stage of vacuum forming is to manufacture a precise mould. This is a skilled job as any imperfections to the mould will show up every time it is used to shape plastic such as high density polystyrene. Bubble wrap is no exception.

The mould can be used hundreds and even thousands of times to produce the same plastic part. Each part will be exactly the same.

The mould is placed in the vacuum former. It is placed centrally.

A sheet of high impact polystyrene sheet is paced above the mold and clamped in position. Various thicknesses are available. This material is 0.06" thick and is the most suitable for this type of vacuum forming.

The heater is turned on. When the machine is being used from ‘cold’ it takes approximately five to ten minutes to warm up to the temperature needed to heat the polystyrene sufficiently.

Once warm, polystyrene of this type takes only four or five minutes to heat up before vacuum forming can begin.

The plastic (polystyrene becomes pliable and flexible after a short time. When the plastic sheet starts to droop from the center, then its ready to be formed. General rule is to have the plastic droop by approximately the same height as the buck is tall.

When the polystyrene is ready the shelf is then lifted up towards the polystyrene sheet. The air underneath the former is pumped out and the polystyrene takes the form of the mold.