Equipment

ATI Nano 17

Description: Load cell measuring forces and moments in 6 degrees of freedom

Number Available: 1

Sensing Range: Fx, Fy = 50N, Fz =70N, Tx, Ty = 0.5Nm, Tz = 0.5Nm

ATI Nano 25

Description: Load cell measuring forces and moments in 6 degrees of freedom

Number Available: 2

Sensing Range: Fx, Fy = 250N, Fz = 1000N, Tx, Ty = 6Nm, Tz = 3.4Nm

ATI Mini 45

Description: Load cell measuring forces and moments in 6 degrees of freedom

Number Available: 4

Sensing Range: Fx, Fy = 290N, Fz = 580N, Tx, Ty, Tz = 10Nm

ATI Omega 85

Description: Load cell measuring forces and moments in 6 degrees of freedom

Number Available: 1

Sensing Range: Fx, Fy = 1900N, Fz = 3800, Tx, Ty = 80Nm, Tz = 80Nm

Scanivalve MPS 4264

Description: Digital pressure scanner for taking pressure measurements

Number Available: 2

Sensing Range: 4" of water (~1000 Pa)

Number of Channels: 64 per unit

Sampling Frequency: Up to 1200 Hz

NIDAQ USB x6343

Description: Data acquisition unit for taking analogue and digital measurements

Number Available: 3

NIDAQ USB 6251

Description: Data acquisition unit for taking analogue and digital measurements

Number Available: 1

NIDAQ USB 6225

Description: Data acquisition unit for taking analogue and digital measurements

Number Available: 1

Smoke Generator

Description: Handheld for flow visualisation

Number available: 1

LaVision PIV

Description: Laser and high speed camera system used for tracking particles and visualising flow

Type: 2D, stereo and tomographic

Ask for further details

Opti-track

Description: 3D tracking and precision motion capture system

Ask for further details

3 x 4 Strut Mount

Description: For use in 3x4 tunnel with Nano 17, 25 or Mini 45. Power supply included.

Number available: 1

Loadcell Plates

Description: Assorted sizes for each loadcell

Ask for further details

3x4 Balance Mounts

Description: Assorted

Ask for further details

Pitot Tubes

Description: Assorted lengths from 300mm up to 1000mm

Number Available: 4

Wind Tunnel Floor/Ceiling

Description: Clean floor for the front and rear and ceiling for the rear test section.

These boards are not to be marked, drilled on for any reasons