Tiny Trailer - Introducing our very first attempt at a camper. it was very small and compact for the three of us. It is based on a Tractor Supply Company 4 X 6 utility trailer and measured 67″ X 84″. Since this was the first camper, we totally overbuilt using dimensional lumber and plywood. It featured 1/2 plywood for the sides and roof construction, 2×4 studs, and nails and screws to hold it together. Sorry I do not have any more pictures other that what is on this page.
Embedded Files
Some
Some
Drawings
Drawings
Fully loaded
Expanded steel trailer subfloor
Electrical Panel
Four Circuits
Final notes:
Final notes:
* I learned the hard way that flat roofs tend to have low spots. However this can be eliminated by adding a slight bow in the center – about ¾ to 1 inch. This slight bow will allow the water to run off and still allow for flat edges. No need to cut complicated shapes.
* The over hang was nice, but at eye level (for me) it was an accident that was waiting to happen!
* I did not run any of the electrical inside the walls. I wanted the build to be simple and easy to maintain. a tip: if you plan on using 120 AC 30 amp power, then make sure that the power cord outlet is on the driver’s side of the trailer (when hooked up to the vehicle). Most RV and state parks have the power distribution on this side of the pull in. It just makes sense not to have to turn the trailer or have extra cord
* Flush mount windows – normally found on mobile homes – work better than what I used. I found mine at a salvage yard new for a low cost.
* Camper was very heavy. However, the axle was in the center and had very little tongue weight which caused the camper to sway a bit. to counter the sway, I always loaded the camper forward of the axle to increase tongue weight.
First camping trip
Google Sites
Report abuse