Advanced Drawer Guides

Side Bore - Setup as many system hole locations as needed you are not limited to 6-locations.

Box Bore - Ability to setup side boring for guide attachment to the drawer box.

Spacers - Can setup spacer blocks with as many holes as needed and not limited to 2-locations.

Fasteners - Setup custom operations in the cabinet side for guides such as IF Perfect Peanut and Lock Dowel

Closet Rod Position Adjustment

Closet Rod Position Adj. - Adjust the closet rod position in the Product Editor>Interior Tab by selecting the "Adjust" icon to move the closet rod forward or backwards in the cabinet.

Cutlist Room Numbers

Cutlist Room Numbers - Added room numbers when going to the Cutlist tab and select the Room drop down menu.

DSlopWDir Parameters

DSlopWDir - Added a new parameter in the Dados category where you can control width slop direction in end parts.

Hardware Leg Levelers

Leg Levelers - Leg levelers can now be setup and added from the Hardware library.

UseLegs - New parameter is added to the Toe category to turn on or off Leg Levelers.

Joint Fastener Re-Vamp

Array - Setup as many system hole locations as needed.  You are not limited to 6-locations.

Custom Fastener Type - Setup custom operations for Fasteners.  Add a flush cover to a Lamello Cabineo.

Drawer Box Joints - Apply Fasteners to a drawer box joint.

Joint Locations - Added many additional joints such as Toe, Shelf Nosing, Nailer, and Panel.

Hardware Reports - Joint Fasteners will appear on Hardware reports by going to File>Print>Print Job>Hardware List

Existing Templates - All existing templates will remain.

Metal Drawer Box Enhancements

Front Bore Tray - You have the ability to bore the front of a tray face.

Metal Drawer Front - Add a drawer sub-front to a metal drawer box.  Add operations to the drawer sub-front and have the ability to adjust sizing.

32mm Linebore Reference - If you have multiple system screws stacked on top of each other you can select which system screw you would like to snap to the 32mm Linebore system.

Nailer Dado

NailerDado - Added new NailerDado parameter to the Nailers category to give the ability to dado the nailers into ends.

NailerQDado -Added new NailerQDado parameter to the Nailers category to make the dado a qualified tenon.

NailerBlindSetBack - Enter value of blind dado setup for Nailers.

NailerTenons - You can select Blind Front or Blind Front and Back for the Blind setback. 

Room Templates

Room Templates - Setup multiple templates in the Room tab for quick change access to different settings.   Room templates also include counter top settings.

Split Dado Parameters

Split Dado Parameters - Split out the DadoTop, DadoBot, StrDado, ParDado, and FixShDado into Base/Wall/Tall parameters.   

Transparent Counter Tops

Transparent Counter Tops - When editing counter tops the counter top color will become transparent so you can see the products under the top.

Advanced Hinges

Advanced Hinges - You can setup 9 different hinges and depending on the product configuration Mozaik will select the correct hinge for the application.