Roller Chain

Desktop Topper

Criteria

• Must be designed in SolidWorks

• Prepared in a slicer for additive manufacturing

• 3D printed in PLA filament

• The object cannot take up more space than as 80mm sphere.

• Unlike the previous year, you must create a ring to fit over the vertical monitor support.  Make sure to use a caliper to measure.  Don’t rely on a peer’s measurements.  The object will then somehow be attached to the side of the ring so that the other student from the other class can also display their  project on the other side of the support.

• Test prints for the ring support are required before full prints (this has to be displayed on the ePort).

Presentation - Place on the Additive Manufacturing page.

(30%) Display challenge instructions (this document) for the viewer to understand the challenge.

(40%) ePort Posts Images and GIFs of modeling/design methods (showing yellow preview) of the object within SolidWorks as well as the slicer program.  Don’t forget to add comments to each image, etc.

• (30%)  Final Design - A GIF of the completed (printed) project.