coin sorter

EDP 6 - Coin Sorter Challenge Design Proposal

These are the two final design pages currently there are measurements for the shelfs and the base and height and the rail that is inside the machine is 8 7/8 inches long .

This page was the intended prototype instead of the coins droping down the chutes and into the shelfs the coins would slide into the shelf which would have made the width of the design bigger and overall made it look thicker which is not the intended design.

data entry's

these two images are the data records of what happened each day during my construction of my coin sorter along with records of testing and the results of the test .

completed build photos

there is the left side of the coin sorter

this is the right side of the coin sorter

here are the storage shelf of the coin sorter

here is the build of the vibrating motor of the build which help the coins move down along the rail

auto cad designs

this is the sorting system itself by sliding down along the rail the coins will fall one by one into the storage shelfs down below

this is the left wall of the coin sorter the holes help push the storage sheld out incase they get stuck inside the coin sorter.

these are the parts for the storage shelf they come seperatly since it is only a laser cutter

this is the original design for the sorter but they where too big so it had to be redesigned

testing videos

20221014_125638 (2).mp4

20221014_130005.mp4

20221014_140414.mp4

Page updated

Google Sites

Report abuse