Mouldings

Leisure 17 & 17SL Rudder

Photo also shows a tiller head fitting. The one shown is in cast alloy; new items are now being machined from solid alloy, but look very similar.

Leisure 17 Anchor LidThis item is supplied ready to fit the boat without further trimming being required.Note: Some Leisure 17's are fitted with the alternative design of locker lid shown below, these are not the same size !

Leisure 20 Rudder & Skeg

The rudder shown has been antifouled. They are normally supplied in white gelcoat finish, and are ready to fit. Note that the rudder has a 'flared' leading edge.

Leisure 20 skegs can also be supplied (no photo available).

Leisure 17 SL Anchor LidThis item is supplied ready to fit the boat without further trimming being required.Note: there is a minor defect in the moulding of the non slip pattern (an old lid with a small scratch was the pattern for the new mould).

Leisure 22 Rudder & Skeg

This rudder was one that was used to make a pattern. New rudders are normally supplied in white gelcoat finish, and are ready to fit. Note the 'flared' leading edge and the heavily 'flared' trailing edge, quite unlike the straight edge of other Leisure yacht rudders.

Leisure 23 and Leisure 23SL Rudder and SkegThe Leisure 23 and Leisure 23SL have identical hull mouldings, and the skeg and rudder are common to both yachts.Both rudders (no photo available) and skegs can be supplied.Note the straight rear edge of the skeg (the rudder has a corresponding straight leading edge, and a straight trailing edge).They are normally supplied in white gelcoat finish, and are ready to fit.

Instrument Pod for the L27 and L29