Main idea to build a simple electronic device that performs two actions at the same time.
i'm interested in motors and LED so i will try to power some.
I used TinkerCad to simulate my project, and to test it before doing it with the breadboard to make sure every thing is correct.
At first I add power supply when connected it with the switch then i connected it with breadboard, I add a resistor, the LED then the motor.
I also used the www.circuit-diagram.org website to draw my diagram and it was easy to use.
At first I test the resistor with the maultimeter to make sure it's the right one i need, then I conected the ON/OFF switch with the power source, after that i test the LED on the breadboard and make sure it's work fine, I also tested the motor and ever thing went very well.
I started to cut out my foam palet to make covering for my little breadboard.
Kindely watch the Video while working from this link. : Video
I got a reasonable feedback it's useless thing but funny to make :D
At first the multimeter didn't give me any read for the resistor but i find out that i was on the 200M ohm and it was very huge for small resistor.
the main idea of my project to run two motor I learned today how to run at least one of it :D
I forget the multimeter ON but I find out if you left it like 5 min without using it will make "beb beb beb noise" to warn you to turn it off to save the battery.