Print this drawing file before starting the project.
Cut to Length
Jointer
Rip Pieces to 2"
Mark Biscuit Location
Use Plate Jointer
Dry Clamp
Glue Legs
Rip and Crosscut Pieces
Dry Clamp
Glue Pieces Together
Plane
Trim Both Ends
Crosscut
Glue Strips Together
Run Through Planer
Glue to Plywood
Clean Off Glue
Cut Legs to Length
Sketch the Rough Location of the Tapers
Layout the Exact Location of the Tapers
Cut the Tapers
Sand the Inside Corners
Cut Rails
Pocket Drill
sand
Assemble Front and Back
Rip Rails
Plane Rails
Crosscut Rails to Length
Pocket Drill
Sand Edges
Assemble Entire Frame
Clean up Glue
Sand
Cut Panels
Install Panels
Make and Install Braces
Make Spacers
Install the Spacers
Droll Pilot Holes
Screw Down Top and Setup CNC Machine
Cut Out and Flush Trim
Cut Out Borders
Assemble Top and Border
Answer Questions
Cut to Length
Cut the Slots
Pocket Drill
Cut Bottom
Sand and Assemble
Router and Install
Create the geometry and toolpaths for the drawer pull
Layout Origin
Router
Make the Drawer Pull
Attach the Drawer Pull
Attach the Top
Apply Finish