Development

Design Ideas

Design Brief

Research

Foam Modeling

Base

Neck

I decided to make the base a little bit more slim and long, so that it could hold the head more steadily. I am going to add white resin where the white bits are.

I felt like the design for my neck was very plain and simple, so I added some holes and I think that it gives it some more character and is a bit more interesting, I just have to make sure that it can hold the head. I would like it to be white as well

Head

I also wanted to make the head slimmer and smaller because before it was very bulky and basically just a block, but very ugly.

Light

I found the light very hard to change, so I went on google and found this, it was very hard to draw so I traced it, but it was still very hard and is not very easy to understand. I should have also made the color a bit better, it is just because I was running out of time and did not have time to make the glowy effect.

Before and After Finished Design

This is the before and after on the finished designs, I feel that the pieces look a lot more smooth and go to better now. The actual drawing of this finished design was very hard to get the angles right because I could not trace so I had to try and get the angles right, which was very hard.

Page updated

Report abuse